Trojan Sideform Connection / Joining

Trojan Production Connection Plates

During the production process it is necessary to temporarily join two lengths of sideform / edgeform to produce the required length of the panel or structure being cast. This however is not a permanent join particularly when excessively long sideform lengths are required and permanently joining the sideforms would make them too heavy and impractical to handle.

SRB utilises Steel Connector Plates in purpose built channels at the rear of the sideforms to simply, quickly and very cost effectively join lengths of sideform for the duration of the manufacture process.

The connector plates are generally left / stored in one end of a standard length sideform simply by turning the knob on the connector plate to lock it in the sideform channel.

The two sideform lengths being joined are abutted end to end and the connector plate is simply released and pushed into the channel of the sideforms being joined so that the plate is engaged in both sideforms. The knobs are then easily hand tightened securing the two sideforms to one another for the length of the production process.

Once the concrete is sufficiently cured for stripping the connector plate is loosened and pushed fully into one sideform and again locked to remain in that sideform. This disconnects the two joined sideforms enabling them to be separately stripped away from the cast member.